THERMAL MANAGEMENT: Radiant Heaters - Thermostats - Hygrostats

Dear reader,

Welcome to another issue of the Pfannenberg e-newsletter. Today we would like to introduce our new range of Thermal Management solutions for enclosures.

Well designed air conditioning equipment for enclosures not only guarantees a high degree of safety and extended service life but also makes sure that your switch gear runs with maximum efficiency. Pfannenberg's Thermal Management solutions offer useful supplementary items and provide additional control for Pfannenberg Filterfans®, heat exchangers and cooling units.

Radiant Heater and Fan Heater series FLH Heat generated by electrical equipment operating under load will prevent the accumulation of condensation. After the equipment has been switched off however it cools down and gradually adapts to the ambient temperature, thus dropping below the dew point. This is the signal that triggers the radiant heater! These sources of heat prevent the formation of condensation by raising the internal temperature a few degrees above the ambient temperature.
	complete product range of 10W up to 400W. to prevent the accumulation of condensation. for enclosures (switch-gear-cabinets) and various outdoor applications. available as radiant or fan heater. Click here for additional information.
Thermostats series FLZ Mechanical bi-metallic thermostat for scure temperature control within enclosures. Suitable as combined product solution for all Pfannenberg Filterfans®, radiant heaters and also for monitoring temperature. Different models available. Equipped as change-over contact with neutral position, NCC or NOC. Operating at increasing temperature. AS-i slave module also available.
	change-over contact with neutral position, NCC or NOC. adapts °C or °F scale AS-i slave module also available with remote temperature sensor. Click here for additional information.
Mechanical Hygrostat FLZ 600 Mechanical hygrostat with change-over contact for triggering heating and / or Filterfan® at a preset level of relative humidity. This maintains the relative humidity above the dew point to prevent condensation and corrosion.
	triggering heating and / or Filterfan® at a preset level of relative humidity. change-over contact maintain relative humidity Click here for additional information.

From time to time we would like to inform you on news, products and events from a leading designer and manufacturer of enclosure climatisation components, thermal management and alarm products in the world. If you do not like to receive this e-newsletter anymore, please reply to the Email address stated below, using the word  "UNSUBSCRIBE" or simply click here: Unsubscribe e-newsletter.

Pfannenberg GmbH - Werner-Witt-Straße 1 - D-21035 Hamburg
Tel.: +49 40 / 7 34 12 - 214, Email: Newsletter@Pfannenberg.com

© 2006 - All rights reserved - Internet: http://www.pfannenberg.com